![]() This process will help begin to flush all the saltwater out of the motor. After you retrieve your outboard motor you should dunk it into freshwater. This process is called pickling and is only recommended if you’re dealing with immersion into saltwater. The first step to correcting the issue to once again dunk your outboard motor into the water. If your outboard ends up being dunked into saltwater because of the weight of rainwater, you’ll be in for a trip. How to Save an Outboard Motor That’s Exposed to Rain or Submerged in Water The salt that’s found in the water is known to cause excessive corrosive damage and will ruin your motor much faster than simply exposure to freshwater. These smaller motors are lightweight and don’t take much room, thus causing them to be sunk much easier than the larger horsepower motors that are available.ĭamage can be even more severe if you’re boating in a saltwater location. Most of the time, the outboard motors that become submerged are of 25 horsepower or smaller. ![]() When this happens, immediate action is required to save your dunked outboard motor. When this happens, your outboard motor may very well become immersed in the water and become waterlogged. This will cause the boat to submerge itself near the dock or boat ramp. If left unattended during periods of hard rain, water can begin to pool in your boat. The other possibility is that someone has forgotten to replace the drain plug or the drain plug isn’t taken out when the rain begins to pour. Over time this can cause serious damage to your outboard motor and will eventually be the death of it. Once the water that’s immersed itself into the motor begins to receive contact from the air, corrosive rusting will begin. But, the entire motor isn’t meant to be exposed to water. Yes, an outboard motor is meant to operate in the water. First, the constant exposure to the rain will cause waterlogging to occur. ![]() When outboard motors get an excessive amount of rain, they can be damaged in more than one way. These are the motors that you can pull out of the water when in storage and then dip it back in when it’s time to get moving. Outboard motors are found on the outside of your boat, typically on the backside. However, outboard motors are much more susceptible to damage from rain and water submersion. Because of this, rainwater won’t be an issue for them. These are designed to be able to handle constant exposure and submersion to the water. Inboard motors rest within the boat or on the underside of it. In general, there are two types of motors that a boat can use. Keep reading to find out how rain can damage your boat motor, how to protect yourself from water and rain damage, and all the best information you should know about rain, water, and how it can affect your boat and its motor. ![]() On the other hand, inboard motors operate inside or underneath the boat and are much better suited to constant exposure to the rain or submersion in water. More specifically, outboard motors are much more likely to receive water damage due to the rain. While this may be true for some motors, not all motors are the same despite what many boat owners believe. So, it makes sense to think that a boat motor can get rained on without a problem. Boats live and operate in the water, it’s where they’re used.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |